My Customized Hilbert Cube

thingiverse

Instructions: Build Custom Version Customize this design using http://www.thingiverse.com/apps/customizer/run?thing_id=781532 Using the following settings: Iterations are set to a maximum of 1 iteration. Randomized features are turned off. The spacing is maintained at its maximum setting, 10 units. Beam characteristics are defined by minimum beam width at 10 units and a current setting at 100 units. This means that any changes made will fall within the bounds of this setup. Minimum and Maximum Spacing Limits are established at their lowest values: 5 units minimum spacing, with an upper limit at 7 units maximum spacing. The system has its iteration capacity set to its smallest configuration with a single iteration as its highest output. This implies that only one iteration will occur before the system reaches its completion stage