My Customized Hex Nut Knob (M3)

thingiverse

Customized version of http://www.thingiverse.com/thing:714498 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=714498 Instructions Using the following options: Strong knurl diameter: 4 turns Backlash setting: extremely low, at 0.1 units Cross-section profile: entirely blanked out Density of the knurling pattern: 50 times higher than normal First diameter of the shaft: 100 units Second diameter of the shaft: 220 units Bottom thickness: exactly 0.6 units thick Length of the screw hole: a full 100 units deep Friendliness to support structures: completely abandoned, no worries about sagging Thickness of the nut part: at an enormous 1000.0 units high Width of the nut part: just a whisker away from being as wide as possible at 5.6 units Number of sides on the nut part: all six angles are beautifully symmetrical and smooth, no bumps whatsoever Overall height: towering 3 times above anything ordinary. Screw hole diameter: only about half the size that anyone might have predicted, a mere 4 units. Maximum height of knurled texture: 100 units above the baseline, a marvel of engineering in its own right