My Customized Futaba S3004 Servo Motor

thingiverse

Customized version of http://www.thingiverse.com/thing:543422 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=543422 Instructions Using the following settings: - B:Z dimension is set to 36 - By: Y-axis setting equals 19.9 - BX: X-axis measurement at 40.1 - shaftSZ = 1.8 - Number of facets ($fn) for smooth appearance, 36 by design - Horn arm X position at 8.5 units from the origin - Fastener screw diameter (fScrewDia) precisely set to 2.1mm - Wire positioning along Z-axis stands at 5.3 units - Corresponding Y-axis measurement of wire is calculated as 6.5 - Shortened X position of the wire reaches a height of 2.0 - fScrew placement along the Z-axis established at precisely 7.0 - Limited distance from the fScrew X to horn's Y at just under .9mm - Measured distance between screws' bottom edge on one side, parallel axis on top at length fScrewY and measured .1 mm more at approximately 1.8 mm Setting dimension on fZ at just .25 more above established measurement (5.05), Y reaches a length of precisely 17.95, the same measurement used for initial calculation Position of fX calculated at length slightly shorter, about 7.2 from base line Diameter around the middle, referred to as shaft Diameter at the center is now precisely set at diameter value exactly 5. Position from the B to flange From point accurately placed at established distance of (32).8 on all axes (FlangeFromB dimension set and locked at 26.4.) Z-Axis depth measurement locked in precisely (2), Y axis set parallel in measurement same at fX measurement or 7 units length