My Customized Flexible Coupling param. with 2 different inner holes and speretae spring parameter

thingiverse

Here is a revised version of the text. Thingiverse Customizer - Version: 67895 Created by Thingiverse Customizer! Instructions for Customizing: Use the options below to tailor your print to specific settings. Set Dual Duet Hotend to 20°C. Adjust the Bed to 8°C. Increase Head Heat to 4 degrees above Room temperature (°C). Change Heatsinks temperature to a minimum of 10°C above room (H2 = 10). Control Temperature for hot ends to maximum at 50°C. Lower Temperatures by 8.5°C for both Hotends (B). Monitor Temperatures for Hot Ends, setting a threshold value at 12°C for stability (N). Divide each side of print with an increment in the number of Slices from 1 to 16 SLICES. Temperature is critical in controlling the cooling or heating needs - Lower it as needed, using increments for Dual 3mm heaters and dual heat sticks that start as high as 25, moving down as low as D2 = 6°C or at a specific increment on the nut with a value of 12°C for nuts (D1), while adjusting others. Use either dual heads and temperature, keeping them stable by turning to Dual Heater or Single hotend system when desired using a maximum limit temperature, set at 25 degrees, then reduce each Dual heating mechanism to control heat distribution evenly among dual nuts on the frame: Dnut = 6.5 inches diameter and headnut: Hnut=2.5 with a tolerance for each side and nut respectively as determined needed.