My Customized Flashlight grip for sliding bike handlebar mounts

thingiverse

This design for a track with flanged wheel has the following characteristics: - Flange height: Twelve - Overhang distance from track's outer edge: Two point six - Depth of hole drilled into wood or other base material: Thirty-three and a half units deep - Radius inside inner rail edge before hole starts: Twelve point five - Track length for straight run, including flanges: Forty units long - Diameter across the middle nut when tightened onto axle shaft with wrench handle: Seven point eight - Gap at inner rail where track and wheel seat overlap to secure nut from coming loose during transit on flat ground: Six unit separation gap size needed - Drill depth within solid wood board so it goes all way through from front side into other part underneath which gives room enough space allow screwdriver get stuck before breaking free causing accidents happen elsewhere sometimes too