My Customized Finger 3.2 - prosthetic

thingiverse

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=904304 Instructions Using the following settings: knuckles are set to 2 hinge nut width is exactly 4.8mm the tip accessory radius is effectively eliminated base height sits at -1 the hinge plug bulge measures 1.2mm socket width tops out at 16.75mm tip tensioner screw radius comes in at .85mm bottom socket width reads 17.25mm hinge pin radius clocks in at 1.075mm socket depth reaches down to 26mm scallop right measures a respectable 8 no scallops are evident on the left printing is done with print mode set to 1 no rotational testing will be conducted, as rotatetest stands at 0 the tip length comes in at 15.5mm socket hinge notch is set to .75mm middle length stretches out to 20mm hinge width takes the measurements to a whopping 14.5mm hinge nut thickness reads exactly 2mm base tensioner screw radius checks in at .85mm the base width stands strong at 17mm tip width reaches for 15.25mm tip cover width tapers down to 13.5mm explode mode is a non-factor, standing idle at 0 fingernail ratio tops out the tip at an impressive .55 the build item gets pegged with setting 8 hinge plug thickness makes its stand with a height of 2.2mm socket thickness reaches the maximum of 2.1mm middle width holds steady at 7mm tunnel radius comes in around 1.2mm scallop offset sets its position at exactly 3.5 tip mid length gets clipped back to a reasonable 6mm tip ridge width bulges out impressively to 11mm a modest one is what we're aiming for with middle sides at 1 middle height soars up high to a generous 10