My Customized Embraer-145

thingiverse

Customized version of https://www.thingiverse.com/thing:693090 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=693090 Instructions Using the following settings: base_plate_outline_1_level is set at 1.5 units high base_plate_outline_2_level measures in at 2.0 units deep The base_plate_level comes out to 1.0 inches tall line_space_factor adjusts by 1.05 units alignment points straight up at the value of 1 big_heart_level holds steady at a level of 1.0 units wide big_heart_outline_level is bumped up to a robust level of 1.5 inches hole_diameter opens up a whole diameter of 4.0 units big small_heart_level gets some extra attention and hits the level mark at 1.5 outline_width stays consistent at a sturdy 3 units in place base_plate_rounding edges get curved over 2 units high for more flair text_height adjusts text height upwards by 8 units higher on display screen lug_level tightens lug placement down to a precise level of 2.0 tight units in tight fit space for better snugness build_lug gets built right into place by the design crew at 1 base_plate_outline_2 gets detailed in 1 unit outline and comes out smooth with base_plate_outline_1 set flatly even at 1 inch too. line2: waits on custom input still un entered here - nothing to show or display so no data just an empty line space left for later input to fill out. line1 sets custom flight path as Embraer-145 with specific designation on the aircraft in use to note model used for identification on flight records. heart_fringe reaches in tight close and snuggly fits heart placement all within a single unit outline mark by small_heart_outline_level reaching level high 2 points. text_space_factor leaves extra empty room space factor of .75 remaining untouched here. text_level adjusts custom print font as specified using the dxf known as KNEWAVE