My Customized Easter Artistic Eggs

thingiverse

This custom 3D printing design was generated from Thingiverse. Created with Customizer, this innovative print is available at www.thingiverse.com/apps/customizer/run?thing_id=54409. To use this print: Use the following settings: Select the egg-style model. Adjust the line width to 2mm. Choose a shell angle of 30 degrees. Design the egg with a width of 100mm. Set the build plate to manual mode at x100 and y100. Configure the middle loop ratio at 10%. Apply an offset of 25% to the loop angle. Determine the percentage of shell material needed as 60%. Select fifteen loops for the design. Opt for manual plate selection at position zero. Choose basic shapes totaling fifty units. Leave loop skipping off at a count of zero units. Set loop width to 5mm and overlap at half that value.