My Customized drying rack

thingiverse

Customized version of http://www.thingiverse.com/thing:911296 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=911296 Instructions: Using the following settings: $fn is set to a high precision value, which increases rendering time but provides more accurate results. Pillars are set to 5mm in width and are placed every 10mm on the grid with 6 spaces between them. The rim around the outer diameter of 127mm is 3mm wide. Racks that fit into this setup will be only 3mm tall to prevent overhangs. Extrusions have a standard 0.37mm width which gives enough clearance for smooth prints and allows a small overhanging edge. Each row's center pillars will increase the grid spacing, thus pillars on outer edges will also rise in line with that change but will maintain 25mm from the floor. Note: Always scale down any item made for your printers maximum bed dimensions.