My Customized Customizeable SMD Pick and Place Manual Feeders Resistor Tape

thingiverse

Customized version of Thingiverse: Bridge and Ramp System (https://www.thingiverse.com/thing:675336) Created with Customizer! (http://www.thingiverse.com/apps/customizer/run?thing_id=675336) Instructions Using the Following Options: • Set bridge_offset to 3 units. • Define side_wall_width at 1 unit. • Establish total_length at 20 units. • Configure ramp_offset_from_bridge to 1 unit. • Determine bottom_thickness as 1 unit. • Designate feeders_count as 5. • Allocate ramp_tail_length at 7 units. • Designate inter_feeder_space as 2 units. • Define tape_slot_width as 13 units. • Define part_slot_width as 7 units. • Set bridge_width to 3 units. • Designate tape_slot_height at 1.5 units. • Designate part_slot_height as 2 units. • Specify bridge_gap at 1.5 units. • Establish ramp_height at 3 units. • Determine top_thickness at 1 unit. • Establish ramp_length at 4 units. • Set part_slot_taper_angle to 25 degrees. • Configure bridge_top_thickness to 1 unit.