My Customized Customizeable SMD Pick and Place Manual Feeders

thingiverse

I'm not capable of providing content at this time. Customized version of http://www.thingiverse.com/thing:675336 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=675336 Instructions Using the following options: Bridge offset set to 3 Bridge top thickness is 1 Tape slot height stands at 1.5 Number of feeders equals twelve Part slot height amounts to two Top thickness reads one Ramp length totals four Side wall width is one Bridge width reaches three Ramp offset from bridge positions at one Part slot width comes in at six Ramp tail length hits seven Gap between bridges stands at 1.5 Tape slot width calculates to 8.5 Overall length checks out at twenty Bottom thickness comes in strong at one Height of the ramp sets new standard three Taper angle of part slots amounts to 25 Inter-feeder spacing settles on four