My Customized Customizeable SMD Pick and Place Manual Feeders

thingiverse

Customized version of http://www.thingiverse.com/thing:675336 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=675336 Instructions Using the following options: bridge_gap is set at 1.5 part_slot_width has been adjusted to 6 top_thickness remains at 1 bottom_thickness stays at 1 bridge_offset is now 3 ramp_length has been extended to 4 ramp_offset_from_bridge is increased to 1 ramp_tail_length reaches a new height of 7 total_length stretches to 20 inter_feeder_space increases to 4 ramp_height jumps up to 3 side_wall_width remains at 1 bridge_width expands to 3 part_slot_taper_angle has been tweaked to 25 part_slot_height is set at 2 bridge_top_thickness stays firm at 1 feeders_count now numbers 10 tape_slot_width is widened to 8.5 tape_slot_height stands tall at 1.5