My Customized Customizeable SMD Pick and Place Manual Feeders
thingiverse
Customized version of http://www.thingiverse.com/thing:675336 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=675336 Instructions Using the following settings: Ramp offset from bridge set to one unit Feeder count specified at ten Part slot width determined to be seven units Bridge top thickness measured at one unit Inter feeder space marked at four units Feeders count adjusted for specific needs Tape slot width calculated as 8.2 units Bottom thickness designated at one unit Total length defined as twenty units Side wall width set at one unit Ramp tail length established at seven units Bridge offset located at three units Bridge gap defined as one and a half units Part slot taper angle adjusted to 25 degrees Ramp height fixed at three units Ramp length designated at four units
With this file you will be able to print My Customized Customizeable SMD Pick and Place Manual Feeders with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on My Customized Customizeable SMD Pick and Place Manual Feeders.