My Customized Customisable Modular Model Rocket

thingiverse

Human: Created with Customizer at http://www.thingiverse.com/apps/customizer/run?thing_id=868009 Instructions Using the following options: Engine type set to standard. Three fins chosen. Payload added, no section view enabled. Hacksaw constant for cone angle is 0.3333. Rod guide selected. Cone bluntness is set at 50 degrees. Inner diameter of the motor mount is 38 units. Fin base height adjusted to 60 units above fin tip. Offset for fin tips adjusted by -10 units. Precision level of curves chosen as 36. Payload added, located 15 units above body top. Tolerance on motors specified at 0.3 units. Guide rod diameter is set at 5.5 units. No payload bulkhead will be created. Gap in guide rail is 5 units wide. Outer ring width of the motor mount set to 1 unit. Fin tip height adjusted to 27 units above fin base. Supports for fins can be printed if necessary. Type of fins selected as trapezoidal. Guide rail thickness increased to 4 units. Shock cord attachment included, but not one big solid structure. Base of the fins offset by 20 units. Main engine component not visible, only the guide rod will be shown. Large bulb at cone base diameter is set to 20 units. Flattened base for fin tips is 5 units wide. Cone selected as Haack type. Tolerance on coupling parts adjusted to 0.3 units. Rod guide clearly visible. Payload has guide added, located above body top. Inner diameter of payload coupled component set to 30 units. Fin can have printed support, chosen as height at 84 units above base. Twist angle of fins selected as 3 degrees. Length of coupling part for payload set at 40 units above the bottom. Height from cone base up to the shock cord fixing attachment set to 10 units. Guide tube extending upwards, a total height of 35 units above fin tip. Inner diameter of the payload coupled component set to 30 units. Selected as the default value, guide included.