My Customized CHIPbag™ - Case for NTC's CHIP

thingiverse

Customized version of http://www.thingiverse.com/thing:1050735 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=1050735 Instructions Using the following options: Bottom on is enabled. Wall thickness is set to 1.75mm. Board height is 61 units. Low profile setting is at level two. Number of sides is 150. Back brick is disabled. Right screw is off. Battery compartment is active. Header height is 52 units. VESA mount is not selected. Side brick is inactive. Left screw is turned off. Back beams are not included. Front panel is on. Board width is 10.75 units. Left header is enabled. Reset option is checked. Sides are active. Side beams are engaged. Right header is disabled. Screw mounts are present. Header width is six units. Top screw is in place. Board length is 42.25 units. Beam height count is eight.