My Customized Box with Lid

thingiverse

Here are the modifications to your settings: Customized version of http://www.thingiverse.com/thing:806968 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=806968 Modifications We are adjusting several variables: coin diameter = 26mm, radius = 13 coin height = 2.5mm Thumb divider presence: Yes Lid offset value: 3 Drawer depth: 23 Enable lid generation: yes Wall thickness: 1.15mm Number of sides for the coin box body (not including base): 0, for the top ring: 11, for the bottom ring: 12 No rounded edges (nose and corners): no Enable small tolerance feature for the parts to snap together snugly: yes Number of times coin is rotated after placement within drawer (coincident with box height), starting at one (which produces the base as shown below) for first layer or 5 if using single, extrude bottom as top ring instead when more than four, also used as starting value of x in drawing lines. The following apply only if 'box_gen' parameter is true : The value used here represents times 15 added to any angle produced and therefore should never exceed value used by last line: Box size X, width: 77, Box size Y, height: 165, Coin Slot option disabled. Selecting type of lid we're making today: Lids come in several flavors; for a custom drawer insert (custom fit): yes , Lids will fit into place and create seal between the two as they were one unit - 3 No 'overhang' at all: no Draw this on box top with given settings applied - 7 Also include an outer frame or housing in final draw: yes