My Customized Belfry mods to USB stick and SD card holder - itae

thingiverse

Customized version of http://www.thingiverse.com/thing:46423 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=46423 Instructions Using the following options: Connector Type set to 0 SD cards chosen for this project: four in number USB sticks selected in bulk: eight units will be needed build plate selector picked by you is number two. Device Order has been determined: one slot taken Sign Height selected: six inches tall Font type preferred for the sign is Letters. Text written on the sign says ITAE THE MAN. A custom position for the build plate in manual mode set to a hundred points along both X and Y axes. A specific gap size chosen for SD cards: 2.5 units of measure applied. The quantity of USB sticks requested has been doubled up: eight total. Six inches designated as gap width between each USB port chosen by design specs. Three unit measurements selected as pencil radius and three as microSD spacing. Customized Cap Height on the top end chosen to one and a half unit for precise fitting purposes only Sign TYPE has now reached number one. Lastly, you chose the device Type - the model picked is a numbered 3 for accurate replication requirements of a fully assembled unit by your own selection