My Customized Belfry mods to USB stick and SD card holder

thingiverse

Created with Customizer! Instructions Using the following options: Device_Type = Card reader device with card holders and pencil. build_plate_selector = Benchtop USB_Extra = 4 USB slots with 4 SD card slots next to each other Connector_Type = 2 connector in line with pen holder Device_Order = Devices go left-to-right, first the micro SD, then the pen, then the regular SD card and finally a second row of devices on the top, last device will be connected. Pencil_gap = A minimum of 4 mm space between the two pens. Sign_TYPE = The text displayed in small letter, build_plate_manual_x = Pads placed under to center on build plate USB_sticks = Each pad with the number on a SD card has a 3D print or rubber base attached so cards will not slip off. Sign_FONT = Using the default font, which has all uppercase letters and numbers and special characters build_plate_manual_y = This tells you that any extra pads must go to the left. If it said to put more down towards bottom they should go right. SD_gap = Spacing of card readers Device_HOLDER_HEIGHT = Sign text on one device with a slight overlap Sign_HEIGHT = Hold in place by two sets of two spring clips (small clips). Connector_gap = All slots must have this extra material at top as the 4 pins go over a pin which are all in one line MicroSD_gap = Small distance in between where pen goes in to connect. Sign_TEXT = Text is Salty Pencil_radius = Dashed line that has no holes.