My Customized Base for Customizalbe Atom

thingiverse

Pin cap width set to default, 0 inches. Pin radius also at default setting, 0 inches. Customizer option chosen for this print: element equals C, lower case L. Plate length and plate width set to manual entry values, both measuring in at a precise hundredth of an inch, equaling 100 hundredths per hundredths unit. Ring height chosen with value inputted in as six, also incremented in five hundredth intervals as required by ring_height_step variable which equates to .5 each increment up to this max. resolution set high with mesh_resolution set at the very high setting of seventy. For a perfect, flat surface build plate preferred type number zero, default choice, chosen by setting Build_Plate_Type equaling zero point oh oh one. Minimum clearance between bottom plate and first printed layer measured .1 units above top. A pin hole radius of nothing added with this selection to customize and streamline the pin process. Lastly, set Build Plate Manual width set at the same manual value, a hundred in increments of a hundedth to make a full centimeter exactly! Set all spacing's down by about 2 and three tenths or roughly two point five of an inch apart to allow sufficient separation on top surface so printed part lays perfectly flat once completed.