My Customized Base for Customizalbe Atom

thingiverse

Here is a customized version of http://www.thingiverse.com/thing:116807. Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=116807 Options: Build Plate Width (Manually) : Set to 100 Pin Hole Radius (Inch) : Leave blank Center Ring Height : Set to 12 inches Clearance Factor : Set to .1 inches Element Material : Ti Mesh Resolution (Inch) : Set to 70 Spacing between rings : Set to 2.5 inches Plate Length Manual (Inch) : Set to 100 inches Pin cap size (No pin-cap) : Set blank Clear Plate Size Width (Manually) : Set to 100 Type of clear plate (Not necessary, I use 0 - it’s for an existing build plate model and will make everything clear): Not set at the moment because my plates don't exist here. Just let the program automatically add these settings when a specific plate is chosen. Ring Diameter Size : Set to 5 inches Pin Diameter No-pin-size : Set to zero so no pins will show at all The last parameter that should remain the same (if you set them equal on both builds - otherwise this part could be easily ignored or done differently depending upon user needs and goals): Plate ring height gap, also sometimes referred as plate ring separation: It is automatically set by my custom code. You may wish to experiment with varying these settings depending on specific plate styles you need to use. The above options will result in an output similar but a customized version to that found in the given example at Thingiverse and other repositories around the world, like http://www.mycraftspace.org/ , as my software is very user friendly, flexible and capable of performing advanced math so can adjust settings according to new plate requirements from users.