My Customized Articulated Ball Joint Fan Mount

thingiverse

Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=139984 Instructions Using the following settings: - Duct Height is set to 110. - Angle is now 45 degrees. - Screw Base Multiplier is at 1.8 times standard size. - Fan Size has been set to 40 mm. - Fan Screw Head Diameter is now 8 mm. - Object Height stands at 24 units high. - Opening is set at 1.2 units in diameter. - Fan Screw Diameter measures exactly 2.8 millimeters. - Nut Height reaches up to 1.6 mm tall. - Clamping Screw Diameter measures 2.8 millimeters in diameter. - Thickness of material used stands at 2 units. - Clip Clearance has been set to 0.3 mm thick. - Small Sphere Diameter is measured as 12 mm. - Screw Head Height adds an extra 0.3 mm to overall height. - Clamp Extension reaches up to 6 units in length. - Screw Distance between two points measures 20 mm apart. - Nut Width across flats equals 4.7 mm. - Central Base Multiplier sits at a value of 1. - Mount Extension stands at 18 mm tall. - $fs or Fine Detail Scaling is set to 0.5. - Nut Clearance gap sits at a distance of 0.2 millimeters deep. - Fan Screw Head Diameter adds up to an additional 4.3 millimeters in size. - Duct Scaling measures just 0.15 times standard width. - Clip Thickness has been calculated as being exactly 1 unit thick. - A Nut Correction value is subtracted from standard measurements, valued at -0.5 mm deep. - Object height measured via vertical dimension stands tall at a whopping 8 units high! - Finally Screw Shaft Diameter measures out at exactly 2.5 millimeters around. - Wall thickness of duct material used in this design now adds up to a value of 1 unit.