MXL Drive Pulley

thingiverse

Here are the Instructions: To Use the Customized Version: The Following Options are Applied: nut shaft distance is set at 2 m3 nut flats measure 5.7 no of nuts to be used is one pulley b dia is twenty two idler height stands at 1.5 m3 nut hex width is one pulley b height is eight idler use is disabled additional tooth depth added is zero nut angle set at ninety degrees motor shaft measures five point two retainer in place with setting zero retainer height one and half m3 nut depth of two seven measured profile is turned on at number one number of teeth applied is thirty two m3 dia stands at three point two pulley t ht measure fifteen This Customized Version was Created Using: http://www.thingiverse.com/apps/customizer/run?thing_id=16627