Mx5 Dynamic TSI

thingiverse

My Dynamic TSI design/work in progress that's based on the full Sketchup model of the mx5 by "The studeö". Again - not added the part of where the holes in for where the Screws go. Designed to fit using the LED Switchback strips that you can easily get off amazon. You buy them long and cut them down. Here's the ones I used: https://www.amazon.co.uk/dp/B07M7JFNMQ?psc=1&ref=ppx_pop_dt_b_asin_title The bulbs fit by sliding up the hole at the bottom and are held in place being a tight snug fit on the rubber seal as well as using the stick back tape on the back of the light I've reduced the size to 98% as well and this fits alot better. Supports are required! - I did mine at 55% overhang Takes 8 hours to print at 0.25 layer height with a 0.8mm nozzle