MWO - Warhammer IIC

thingiverse

I removed some small parts and other elements that were too tiny to print at the usual scale used by our community, which is 10mm / 6mm. Some of the armor pieces I had to combine because they were floating in mid-air. I printed the legs first and found out that the feet were very small. When I looked at the back part of the feet, I decided to lower the part so it's level with the floor for better standing stability. I included the unmodified version as well since those using hex bases might not have any issues. You can see the uploaded image of the back of the feet. You may need to glue the arms in place because they slot into the shoulder armor parts from underneath. To get the complete model, just mirror the right side for the left. I included a complete version that you can use to figure out your desired scale. Edit: I'm fixing the holes in the front torso and will upload a new version once it's done. Sorry about that. Edit 2: I removed all the internal junk and plugged up as many holes as I could find. It's much better now. I also included the arms with the bars at the bottom. Smaller scale prints might have trouble with those, but bigger prints should be fine. I made them slightly fatter and attached more surface area to the arm for a stronger hold. I changed the hip pins by making them longer for a more stable stand. I made the missile launcher holes deeper so they can be seen better once printed. I fixed the cockpit area where the windows were messy before.