Mustang CARtoon mash-up

thingiverse

I've been trying to merge pre-made parts like a car body, wheels, and engine into one solid object for CARtoons Magazine's CARtoony look. It was tougher than I anticipated due to my lack of 3D skills. Assembling the pieces wasn't a challenge, but making it a print-ready solid was. I managed to figure it out after some trial and error. A small test print at low resolution resulted in a blurry model that looked unimpressive. However, when printed at full size (approximately 140mm), it should turn out fine. The complete model along with a split version is included below. Special thanks to: MakersBox for the car body cerberus333 for the tires ekyzlopez for the wheels gCreate for the smoke Schlauncha for the supercharger (blower) mikethinks for the flame AirportMichael for his inspiration Print Settings: Printer: Fabrikator Rafts: No Supports: Yes Resolution: 0.2 Infill: 15% Note: The model was printed using Cura, but it's unclear if other slicers will work as well. There are some issues with the model that Cura seems to ignore, which is beneficial. If you print this model, please report your findings.