Mushroom lamp Base / Stand

thingiverse

I needed a compact base for this awesome mushroom lamp design. So, I quickly designed one in Fusion360. It's aligned with the original file of the mushroom stem. You can use this to house small electronics for the LEDs or lamp. The top can be glued or screwed into the mushroom stem using tiny screws. The bottom and top parts just fit together by friction, allowing access to the electronics, etc. I included a small hole in the top part for the switch that came with the LED light. This might be too narrow for other switches; the hole could be used for small wires instead. Prints support is free! See added pictures. I printed this base using genuine Green PLA. The print settings were: slow profile, 0.2 layer height, 20% infill, no supports or raft/brim, a hotend temperature of 210c, and a bed temperature of 60c. I used a LED disk road emergency light bought at a dollar store (it's for when your car breaks down, etc). I did some soldering work on the LEDs and switch to lengthen them.