Multiplex MPX O'Ring wing connector

thingiverse

Housing for MPX type connectors enables a reliable connection for servos on removable wings. Type-A housing does not require trimming. The female side of the MPX connector is glued in from the front of the housing. Type-C housing requires a small amount of trimming to enable pins to insert fully into the male connector (please see pictures). The female part is inserted and glued in from the rear of the housing. Both wing connector versions use prop saver O'rings to hold the two sides together. Angled holes can have 2mm Dia rods inserted to anchor the housing to the foam. The housing has been tweaked for a better fit with connectors. Some MPX connectors are slightly misaligned when glued together. Fitting both male and female together and sanding to remove any misalignment is suggested. Revised on March 3, 2020