multimeter v3

thingiverse

Customized version of Thingiverse item ID: 537516. Created with Customizer! Using the following settings: * Holder Y size set to 50 * No cutout on the holder's side, value is at 0.0 * The corner radius has been increased to a full curve by setting it to 20 units. * Hanger angle set to perfectly straight, no degree change with 0.0 * Set to standard strength levels as tapered ratio at its default state of 1.0 * Wall thickness of the entire structure set at 3 for added durability * Using one vertical support column * Only slightly strengthening overall framework to moderate by setting it to .66, with value being less than .70. No solid bottom with no wall height left when option is off as we've got 0.0 Hanger depth or width not adjusted as its already optimized, default 0 units deep. Holder total height increased to maximum potential set at 70 mm in full height setting from initial minimum, for additional balance on load bearing points. Set number of hangers along X-axis (right-left side) and set their width from original values at full range from right at a massive size adjustment up to max set point to accommodate larger loads. Number of vertical holders increased so it goes all the way through along with X direction support as set, allowing us hold heavy items properly in line while adding additional reinforcement across wide parts without being overbuilt which saves cost and resources when used carefully under correct loading scenarios but be mindful how often or lightly weight loaded -