Multimeter Holder / Wall Bracket for Duratool D03041

prusaprinters

Holds D03041 multimeter and at least two sets of probes / leadsPrint SettingsPrinter Brand:CrealityPrinter: CR-20Rafts:YesSupports: YesResolution:200Infill: 38Filament: ASA  Notes: This large print took well over 24H on the CR20 using fairly conservative speeds.Even with raft, the ASA material warped and split a little at the corners. However these defects appeared minor on the finished item, and the central compartment for the multimeter turned out undistorted.The item was designed to be printed at a 30 degree angle and using tree supports.If using ASA then would recommend to use large rafts as possible, and strong contacts between raft and bed; raft and component. Enclosed printing area, fan off. FreeCAD source model included  Category: Electronics