MultiMax Enclosure

prusaprinters

An enclosure to suit Rob Clarke and Michal Pleban's "MultiMax" cartridge for the Commodore Max Machine and 64. It provides access to the reset button and is styled to mirror official Commodore cartridges of the day as close as possible. No fasteners are required - just clip the two parts together.Note that the bottom piece is designed specifically to fit Michal Pleban's hardware design, which includes two half-circle notches near the edge connector.A “Flat” variant of the top piece is provided. This will only fit if the ROM chip and controller chip are not socketed as otherwise there is insufficient clearance. Only one of the Top pieces is required. The standard Top piece requires supports for the raised shelf. No other supports are necessary for any piece. Material choice should be largely irrelevant as this is not exposed to heat or extreme loads.