Multicopter motor mount for 1/2" square booms

thingiverse

I've built a reliable motor mount suitable for any copter that utilizes 1/2-inch square booms. It's a simple design, yet effectively meets its purpose. I chose to print it in ABS as my motors tend to run quite hot, but in practice, the mounts never reach uncomfortably warm temperatures, so PLA could be an acceptable alternative - please let me know if you experiment with that! After printing, I noticed these sometimes appeared a bit messy because the first layer of the bridge didn't turn out perfectly every time. To mitigate this issue, I added a small tab that can easily be removed after printing. It provides minimal support to the visible area. Print Details Printer Used: Hic Hic i3 Rafting Settings: Not Necessary Support Settings: Not Required Resolution Setting: 0.2 Infill Density: 100%