Switch holder for Skadis

What is it?It's a switch holder for Ikea Skadis! It can hold a little slide switch with M2.5 screws with or without nuts. It uses a hook and a peg to secure it in the typical oblong spacing of the skadis plate.Why though?Wifey got me a nice neon light of a controller, I wanted to fit it in my skadis network "rack" but I didn't want to have the switch dangling around so I had this idea to make a holder for a little switch.Will it fit?Short answer, yes.It's snug because I didn't want it to move around when I flick the switch. The hook has rounded edges to make insertion easy.Bear in mind it uses 2 holes in the skadis plate, top hole for the hook, bottom hole for the peg.I made sure there is enough space for the wires to comme either way.For the screws I used M2.5x4mm but you can go up to M2.5x10mmI'll say it again in the print note but:Print the support on it's sideOtherwise the hook will snap, see the print note for more infoHow should I print this?I have an Alfawise U20 and I don't trust it a lot so these setting will probably be overkill if you have a fancy 3D printerWall line count: 3 to 4Top/Bottom layers: 4Infill: 25 to 30% GyroidSupport: YesRaft: Yes 5 to 8mm