Multi-Tier Jewelry Holder

youmagine

This project was finished as part of a 3D printing course at Michigan Technological University. Assuming a standard roll of PLA filament costs $22, this part costs $2.84 to produce. This is a savings of $95.16 compared to the jewelry holder I used for inspiration. Each tier is printed separately. The posts are also printed individually and snap-fit into the bowls. To assemble the four tiers and posts, you don't need any glue or other fasteners. The biggest tier (first tier) is 154mm in diameter, while the other three tiers are smaller in diameter. The largest bottom tier takes approximately 3 hours to print using a MOST-Athena Delta printer, and the smallest top tier takes approximately 25 minutes.