MudPuppy

thingiverse

5 Piece Segmented surface lure we designed in fusion 360 then Airbrushed (Work In Progress ) INCLUDES SEGMENTED APPENDAGES!!! ⚠️⚠️I used small sections of toothpicks approx (2.5mm) as pegs to align the halves until the epoxy set (use clamps or weight) ⚠️⚠️ Uses eye bolts and poly ribbon to create hinges. Lighter Infill will allow the lure to float Some tuning might be needed to get these to stay upright in the water but I haven't had much difficulty in doing so (Note lighter lures seem to be just fine with the weight of the hooks being able to keep the lure upright. ⚠️⚠️Until I can get predetermined hard points inserted into the body I recommend printing this at a dense infill ( more than 30%) this just insures that the eyebolts have sufficient material to hold onto and not just pull out of the lure.⚠️⚠️ CHANGE SLICER UNITS TO MM or else HARWARE WILL NOT FIT! https://www.youtube.com/watch?v=9NCVeAyxofk&feature=youtu.be Music: https://www.bensound.com