Mud/splash guard for EVOLVE skateboard -"FRONT AND BACK"-

thingiverse

This is a supplement for the belt guard I've made, which will fit over but be careful - it's a tight squeeze. The easiest way to get them on is simply to screw in just the wheels (not the drive) and you'll be good to go. Alternatively, you can fit them with the wheels still attached. I added some front guards too; they're not perfect, but they do the trick. You'll need four 3mm x 10mm flat-headed screws and bolts to set it up. Files: Front Guard Holder - Forskærm Guard Front - Skærm Right Rear Guard - Skærm_højre Left Rear Guard - Skærm_venstre Be aware that this thing is still evolving, so it may change all the time. Print Settings: Printer: DAvinci Rafts: No Supports: No Infill: 10% Notes: 4 top layers 4 bottom layers 3 outline layers Printed in ABS Bed temperature: 110 degrees C Nozzle temperature: 230 degrees C Speed: 45 mm/s Estimated print time: 3-4 hours