MT2 MK2 Toolholder Lathe Tailstock Tools

thingiverse

MT2 MK2 Tool Holder for Morse Taper Tools. I'm pretty sure most people have one Chuck, one Live and one Dead center, so there are three holes to accommodate this with a little space between them. It won't fall over. Either Jacobs or Quickchuck should fit just fine. Print settings I used aren't anything special - I went with 0.3 layer height, fast print settings. The only specialty is that I like to print with 3-4 outer shells, which negates the infill, so I can go 10 or 5% without losing any structural integrity. No support needed. If you want, you can go a few percent oversized so the MT2 falls better into the hole. Mine was a bit narrow, but it still works. Print time is around 5 hours and 30 minutes. My toolbox is much cleaner now. For other projects I make, do or create, check out my Instagram: https://www.instagram.com/roger.egli/ YouTube playlists for model and machining hobbies: https://www.youtube.com/user/MrZhefish/playlists I hope it's helpful! Cheers.