MT07 FZ07 R6/Motion Pro Throttle Tube Mod

thingiverse

EDIT: Unlike my original indication that a snap fit would be enough, after futher testing i recommend gluing the spacer on the throttle with some cyanoacrylate or epoxy glue as I noticed they tend to break when under load if not glued. Maybe it's just my old brittle PETG filament and it won't happenen with a stronger material, but I'd rather not take my chances as it is pretty annoying having to swap the spacer every couple weeks because it broke. Granted it's not dangerous, as it is pretty snug in the case so it wont jam in there and make the throttle stick open, only a little more stiff to twist. A simple clip-on throttle spacer to achieve R6-like throttle throw. Features a groove to seat the cable and about 40mm diameter (calculated inside the groove), just like an OEM R6 throttle tube I also included a version with similar throw to the Motion Pro throttle tube, for anyone who feels the R6 to be too quick. No need to glue it in place as the tension from the cable will prevent it from moving left and right, plus its a pretty close fit so it won't rotate. I you do decide to glue it for peace of mind be sure to scuff both surfaces with somewhat coarse sandpaper and use epoxy glue as cyanoacrylate will likely crack and fail after a bit.