Mt Adams

thingiverse

As I submit each piece, I record them. The marker at the base points towards North. When printing, I highly recommend utilizing PrusaSlicer's layer editing feature. Set the foundation up for printing at .35mm then as much of the mountainous terrain at .10mm as possible. This will result in a good balance between print quality and speed. I also advise using infill around 30-40%. I know, that's relatively high for a model that doesn't really require the strength. However, trust me. Setting the infill too low WILL lead to layer shift. See image of layer shift error. There's nothing worse than being 18 hours into a print job just to have it fail like this.