MSP430 Launchpad Case

thingiverse

Two piece small clean enclosure designed specifically for the MSP430 Launchpad. The green and red LED's on the launchpad are clearly visible with the enclosure cover in place, thanks to two strategically placed holes at the top that allow access to the push buttons. Female header pins on the underside of the launchpad are exposed in the lower part of the enclosure, fitting flush against the bottom surface. This design prints exceptionally well regardless of settings and provides an excellent small and lightweight case for protecting your MCU. The top cover is securely attached using 4x M3x0.5mmx8mm socket cap bolts that thread directly into M3x0.5mmx3.8mm heat set inserts installed in the lower part of the enclosure. If you need to replicate this project, the required part numbers are listed below. McMaster-Carr Part Nos. 4x - M3x0.5mmx8mm socket cap bolts: 92290A113 4x - M3x0.5mmx3.8mm heat set inserts: 94180A331 For all your 3D printing needs, check out www.mattertec3d.com. You can also view a similar enclosure design for an Arduino Leonardo at http://www.thingiverse.com/thing:1441657