MSI Optix MAG24C VESA 100 Adapter

thingiverse

This is a remix fromhttps://www.printables.com/en/model/223063-msi-optix-g24c-vesa-adapter-100x100/filesI could not find a complete file I modified this one and it works perfectly. The curved monitor has a different mount than the straight one so it called for the modificationsI Used 5 walls everywhere top bottom and sides and 50%infill of triangles/ part came off perfectly with no brim neededAdditional Hardware Needed4x M4 X 206 Flat washers for spacers at bottom of mountI used 4 m4 x 20 to mount the piece to the screen and then just found bolts that were long enough to fit through the mount and the spacer. The only additional post processing was recessing the nuts through the back end with my soldering iron to capture the nuts. There is very little clearance after you attach it to the screen. So my method was to remove the mounting metal plate from the wall mount and feeding the screws through adapter so they would be in the correct position. then i set my soldering iron up as high as it would go and placed it against the metal nuts, while tightening the screws until the nut was captured and flush with the mount (see pictures) After that remove the mounting plate, attach the adapter to the monitor and screw the mount to the adapter. If you have thread inserts this will work as well but this is what I had on hand. I also placed 2 washers on each bottom vesa screw to square up the mount, but if you have appropriate bolts you may not need these