Mrs. Pacman Joystick Fix

thingiverse

Printed the cross at 100% since it was the original part that had broken. The joystick needed to be removed completely in order to take it out, which likely voided the warranty. Note: On the cross, the up and down protrusions are slightly higher than the left and right. This is done to fix a problem with the original game controller that did not move up or down very well. You will need to orient the higher protrusions in the up and down direction. The pivot dome goes on top of the cross. Nothing was glued as the rod seemed tight enough to hold everything together. A 6mm steel rod, pulled out from an old printer, is used for the shaft.