MRM Santoku Parts

thingiverse

Multi Rotor Mania Santoku Parts Repository - Check out the official parts for the MRM Santoku, originally designed as a Connex frame but now used with Standard FPV gear. Parts to mount this gear are included below. All parts are meant to be printed from TPU or similar flexible materials unless otherwise noted. Some parts need duplicates. Mirror and duplicate on the bed as necessary. MRM Santoku - Antenna Mount: 45-degree SMA antenna mount. Use either TBS flange or standard SMA extensions. MRM Santoku - SMA Antenna Mount: SMA antenna mount with SMA positioned vertically. Standard SMA extensions are recommended. MRM Santoku - Arm Protection: Arm guard/soft mount for motors. Print a mirror image for the opposite side in your slicer. MRM Santoku - Arm Protection Extended: Arm guard/soft mount for motors, extended to help during launch and motor protection. A mirror image is required for the opposite side in your slicer. HS1177 Cam Plates: Camera Mount plates with holes positioned to hold a standard FPV camera. Print these plates in a rigid material like ABS, PETG, or PLA. MRM Santoku - VTX Mount Insert: Designed to mount a standard VTX in place of the Connex System. Zip tie slots are included for holding the VTX. 5mm Antenna Tube Mount: Securely holds an antenna tube with this mounting system. Route your receiver's antenna up through the small hole at the bottom and print its mirror image on the other side. We typically print all parts at a 0.2mm layer height in TPU, using 25% infill works well for these small parts, along with three perimeters, four top & bottom layers, and support as needed.