MRM Reaper Arm Protection

thingiverse

Here are the arm protectors for the MRM Reaper Frame.\n7-12-17: An extended version was added for the 5mm arms. These protectors work great on my Stretch Reaper's front, allowing you to start the copter flat and then tilt forward into a launch position without the props touching the ground. They're perfect when running a very high camera angle and can't see the first gate while sitting flat on the battery.\nhttp://www.multirotormania.com/200mm-smaller-micro/1448-mrm-reaper-195220-fpv-racing-frame.html\nThese protectors will work with TPU or a rigid material, and can be mounted from the bottom or between the motor and frame. Each arm protector weighs in at 2.6g printed at 0.2mm with 25% infill.\nThere is a file available for both 4mm and 5mm arms, and the 5mm fits both 195 and 220 arms.\nPrint Settings\nPrinter Brand: Robo 3D\nPrinter Model: R1 ABS + PLA\nRafts: None\nSupports: None\nResolution: 0.2mm or 20 Microns\nInfill: 25%\nNotes: Three perimeters are preferred, but others print fine too.