MPSM V2 Z Carriage

thingiverse

I made a remix of mfink70's Z carriage with holes for mounting a lead screw nut - https://www.thingiverse.com/thing:2764817\r\n\r\nI purchased mine early/mid 2018. mfink70's carriage has unevenly placed bearing holes, which when mounted causes the X gantry to sit at an angle. \r\n\r\nThis version has the bearings' holes repositioned for later V2 generations. I have also added screw support for the X gantry cover.\r\n\r\nYou can either print the whole carriage as one piece with quite a bit of support, or for convenience, I've split the carriage into two printable halves, each requiring only minimal support. \r\n\r\nIf you do print the halves, glue them together with the bearings already in place so they act as positioning guides; otherwise, it takes a lot of care to ensure the X rods remain aligned between the two halves...