MPMD Bed hold down clips

thingiverse

These clips are a work in progress, so I'd really appreciate your feedback if you try them out. To get started, you'll need to open up the printer case. If you're not comfortable doing that, there's another clip option available at https://www.thingiverse.com/thing:3380266. This is a version of a bed hold down clip designed for the Monoprice mini Delta. I've included two versions of the base, with one featuring an added debris shield (inspired by https://www.thingiverse.com/thing:3380266). To assemble the clips, print three tabs and three bases according to your preference. Required hardware includes: 3x M3 nuts 3x M3x10mm screws 3x 6mm or shorter screws (approximately M3 in size) Installation instructions follow: Don't install the tabs until I instruct you to do so! Remove the top and bottom covers from the printer's base. Be careful, as the display panel will be loose and can be unplugged for safekeeping. It's not necessary to remove any other parts, but be mindful of where each plug connects if you choose to do so. Next, remove the stock bed clips and replace them with one of the bases. The small circle on the base's bottom should fit snugly into the hole, and a screw from below will hold it in place. Once all three bases are installed, reattach the display and top plate of the printer's base. Replace the print bed, then prepare the tabs by placing an M3 nut in each tab's slot. Install the tabs by inserting the pins into the base's slot, with the nut facing away from the print bed. Gently push the tab toward the print bed until it clicks into place. Insert the M3x10mm screws into the back of the tabs, through the nut. Adjust the screws to achieve just enough play for the bed switches to be activated and deactivated. For further calibration information, visit https://www.mpminidelta.com/start