MPM Megatron Mace

thingiverse

This is the Transformers Movie Masterpiece (MPM, or Masterpiece movie) Megatron (almost) Movie Accurate mace, it requires a small bendable wire, I used 4 big paper clips on each side instead. "WireMace" model is from Toymakr3d (his shockwave model): https://www.toymakr3d.com/ I added hot glue everywhere for details (add hot glue around "Macehandle" (Except the slot) before inserting it into arm; it may be too tight and get stuck in there so sand it down a bit) I am in the middle of modeling very posable hands for mpm megatron, I will not be making a movie accurate mpm megatron head, as I do not have the skill for it, if you do-please 3d model it as it would enhance the overall figure imo Please post a make as i'd like to know if posting these models online are even doing anything Instructions: ***IMPORTANT*** DO NOT NO MATTER WHAT, ADD HOT GLUE TO THE SLOT THAT GOES INTO THE ARM Print ---> 4 <--- WireMace pieces Print ---> 1 <--- MaceHandle Print ---> 1 <--- MPM Megatron mace Sand down MaceHandle so it fits in snuggly and not too tight Use two bendy wires and add WireMace on each end of the two bendy wires add a lot of hot glue to the WireMace and into the holes in MaceHandle and MPM Megatron Mace then connect them and let the hot glue dry so they are stabily intact add hot glue around the wires for the spiked chain effect in the movie add hot glue on MPM Megatron Mace and MaceHandle for more detail You can always message me privately if you wish.