MPCNC Z Axis Cable Raceway

thingiverse

This is a basic collection of brackets intended to bolt onto the Y-axis stepper motors, enclosing a 1/16"x1" piece of angle aluminum. You can either lay a cable chain in the channel or use the included printable clamp to secure your Z-axis wiring out of the way. All pieces print without support, I use three perimeters and fifty-five percent infill, though none of the pieces have significant amounts of infill. In addition to the printed parts, you will need: * A piece of 1/16" x 1" angle aluminum slightly shorter than your Y axis * Eight M3 x 10mm bolts (these replace the stock stepper motor bolts which are too short to clear the brackets and stock parts)