MPCNC E3D V6 Mount

thingiverse

This is a custom E3D V6 mount designed for the MPCNC machine by Allted. It attaches to the original tool holder using two #8 bolts and lock-nuts. Mount it in the second-to-last holes from the bottom to achieve more Z height, but be aware that you may need to modify the endstop mount if you want to move the hot end up further. However, do not install it in the lowest set of holes, as this will reduce Z height and cause wobble. Instead, follow these guidelines: Hardware Requirements: You will need two M3 bolts and two M3 nuts to assemble the mount. The clamp piece is designed to fit only one way, so if it doesn't fit properly, simply swap it around. Assembly Instructions: The bolts that screw into the nut trap can be a bit tricky to handle, but you can use a screwdriver to hold them in place while tightening. Don't over-tighten the bolts, as the mount will still function effectively even with loose screws. Print Settings: Printer Brand: Solidoodle Printer Model: Solidoodle 4 Raft Settings: Not required Support Settings: None Resolution: 0.3mm Infill Percentage: 20-30%