MP Select Mini V2 Feeder for Flex TPU

thingiverse

This is still a work in progress, but it works already. MP Select Mini V2 Feeder Base plate, Arm, Cover, and Guide/Spacer are included. Make sure to print each piece separately and flat. You will need a couple shorter screws, but all the other stock hardware should fit fine. What's different about this compared to the V1? The spring was too loose on the V1 version, so it got compressed a bit more. If the spring is too loose, feeding will stop and prints will be thin. A pin for the bearing was added. The screw holes were resized so no additional hardware is needed. The feeder guide serves as a spacer for the stock long screws and helps out. It's designed to swing over the arm. The pin to clamp in the bowden tube connector still needs work - it doesn't fit fully yet. The V1 uses a bolt, while the V2 relies on pressure fit. It should hold, but without the clip, it will eventually push out. This thing was made with Tinkercad. Edit it online at https://www.tinkercad.com/things/8JHpy9SO4Ru