MP Select Mini Tool Holder and Filament Guide

thingiverse

I just merged the tool holder and filter guide in Tinkercad, adding support to the guide so it prints upright/vertically like the original holder, with minimal supports. This way, it can be used as a filament guide too. I tweaked the holder to mount on the front of the printer instead of the back. You can see the original item's notes below. Tool Holder: Original - https://www.thingiverse.com/thing:1688459 A tool holder bracket and miscellaneous tool holders for the Monoprice MP Select Mini. Remove the top 2 screws and attach the bracket with them. I removed the small washers but that might not be necessary. The pieces that slide in are fairly loose, but it hasn't been a problem so far. You could always glue them in place. Filament Guide: Original - https://www.thingiverse.com/thing:1776777 Someone said this filament guide still works fine with the filament filter (available elsewhere). He said the filter just rides between the guide and the extruder. A suggestion was made to add a piece of nylon tape to the guide where the filament rubs against it, but so far I'm content without it. This borrows from jasonjones' Filter Bar and converts it to a filament guide for those who don't want to use a filter. It uses the stock screws with washers like the original.